WWW
.
CLF
-
LIGHTING
.
COM
8
.
0
SETUP
Warning! Read “Safety Information” on page 2 before installing, powering, operating the fixture.
Control panel and menu navigation
The onboard control panel and backlit graphic display are used to set the fixture’s DMX address, configure
individual fixture settings (personality), read out data and execute service utilities. See “Onboard control
menus” on page 15 for a complete list of menus and commands.
Using the control buttons
• To enter the menu select [MODE].
• Press [UP] and [DOWN] to scroll within a menu or adjust values.
• To enter a menu, select a function or apply a selection, press [ENTER].
• To escape a function or move back one level in the menu structure, press [MODE].
• Holding down the "UP" and "DOWN" button for more than 3 seconds, the MENU display will rotate 180°.
DMX address setting
The DMX address, also known as the start channel, is the first channel used to receive instructions from the controller.
For independent control, each fixture must be assigned its to a separate channel .
The DMX address can be configured by using the DMX ADDRESS menu in the control panel. For setting the
DMX address press [ENTER] before you can change the adddres.
• In order to check if there is a DMX signal present on the fixture you can easy see that via the big ‚DOT’ on the
main screen and also when the backlight function is switched to off.
• The fixture is fully RDM ready. So when you are using a RDM ready console you can address the unit and
read out its complete status. For RDM functions please refer to the ANSI/ESTA E1.20-2006 standard
Control mode
DMX control mode is selected in the CONTROL MODE menu. The fixture has 6 DMX control modes:
4ch
6ch
7ch
11ch
Dimmer
RGBW
Strobe
CCT
Macro color
Effect
Dimmer
/
Effect
speed
Function set
HSV
HSI
Hue
Saturation
Value
Intensity
