WWW
.
CLF
-
LIGHTING
.
COM
8
.
0
SETUP
Warning! Read “Safety Information” on page 2 before installing, powering, operating the fixture.
Control panel and menu navigation
The onboard control panel and backlit graphic display are used to set the fixture’s DMX address, configure
individual fixture settings (personality), read out data and execute service utilities. See “Onboard control
menus” on page 23 for a complete list of menus and commands.
Using the control buttons
• To enter the menu select [MODE].
• Press [UP] and [DOWN] to scroll within a menu or adjust values.
• To enter a menu, select a function or apply a selection, press [ENTER].
• To escape a function or move back one level in the menu structure, press [MODE].
• Holding down the "UP" and "DOWN" button for more than 3 seconds, the MENU display
180°.
DMX address setting
The DMX address, also known as the start channel, is the first channel used to receive instructions from the controller.
For independent control, each fixture must be assigned to a separate channel.
The DMX address can be configured by using the DMX ADDRESS menu in the control panel. For setting the
DMX address press [ENTER] before you can change the address.
• The main screen will show a 'dot' and the backlight will be switched off when a DMX signal is detected.
• The fixture is fully RDM ready. So when you are using a RDM ready console you can address the unit and
read out its complete status. For RDM functions please refer to the ANSI/ESTA E1.20-2006 standard
will rotate
W-DMX control
Go to the W-DMX section in the main menu, press
the
button
“
UP”
to
switch
off
Wireless
DMX
or
disconnect
with
all
connected
Transmitters
.
Press
the
button
“
DOWN'
to
set
the
unit
in
the
”ready
to
connect
with
all
not
connected
transmitters'
mode
.
If
you
press
the
mode
button
on
the
Wireless
solution
transmitter
all
the
units in this mode will
be connected
.
If
the
unit
is
successfully
connected
in
the
home
display
the
sign
“
:
V
”
.
Appears
.
If
the
unit
is
not
connected
to
a
transmitter
in
the
home
display
the
sign
“
:
X
”
.
If
the
unit
is
switched
off
in
the
home
display
the
sign
“
:
OFF
”
.
l
Holding the
MENU
and
ENTER
button for more than 3 seconds, the wireless board will reset.
l
Do not use Wireless DMX and Wired DMX at the same time because it will give unwanted interference
