Clevo W251BLQ, Руководство по обслуживанию

Страница: 34 / 89

Disassembly
2 - 10 Removing the System Memory (RAM)
2.Disassembly
5. Pull the latches to release the second module if necessary.
6. Insert a new module holding it at about a 30° angle and fit the connectors firmly into the memory slot.
7. The module will only fit one way as defined by its pin alignment. Make sure the module is seated as far into the slot
as it will go. DO NOT FORCE IT; it should fit without much pressure.
8. Press the module in and down towards the mainboard until the slot levers click into place to secure the module.
9. Replace the bay cover and screws ( make sure you reconnect the fan cable before screwing down the bay
cover ).
Note that there are four cover pins which need to be aligned with slots in the case, to insure a proper cover fit,
before screwing down the bay cover ( Figure 6 d ).
10. Restart the computer to allow the BIOS to register the new memory configuration as it starts up.
e.
Figure 6
RAM Module
Removal (cont’d.)
e. Properly re-insert the
bay cover pins.