Clevo N770WU, Руководство по обслуживанию

Страница: 24 / 42

Disassembly
2 - 2 Overview
2
.D
is
a
ss
e
m
b
ly
NOTE : All disassembly procedures assume that the system is turned OFF , and disconnected from any power supply (the
battery is removed too).
Maintenance Tools
The following tools are recommended when working on the notebook PC:
• M3 Philips-head screwdriver
• M2.5 Philips-head screwdriver (magnetized)
• M2 Philips-head screwdriver
• Small flat-head screwdriver
• Pair of needle-nose pliers
• Anti-static wrist-strap
Connections
Connections within the computer are one of four types:
Locking collar sockets for ribbon connectors To release these connectors, use a small flat-head screwdriver to gen-
tly pry the locking collar away from its base. When replacing the con-
nection, make sure the connector is oriented in the same way. The pin1
side is usually not indicated.
Pressure sockets for multi-wire connectors To release this connector type, grasp it at its head and gently rock it
from side to side as you pull it out. Do not pull on the wires them-
selves. When replacing the connection, do not try to force it. The sock-
et only fits one way.
Pressure sockets for ribbon connectors To release these connectors, use a small pair of needle-nose pliers to
gently lift the connector away from its socket. When replacing the
connection, make sure the connector is oriented in the same way. The
pin1 side is usually not indicated.
Board-to-board or multi-pin sockets To separate the boards, gently rock them from side to side as you pull
them apart. If the connection is very tight, use a small flat-head screw-
driver - use just enough force to start.