Clevo LP2600C, Руководство по обслуживанию

Страница: 26 / 111

2 – 7 2 – 7
2 – 7 2 – 7 2 – 7
2
D
ISASSEMBLY
DIMM Removal & Installation
M
EMORY
M
ODULE
R
EMOVAL
R
EMOVING
DIMM
S
Part A
Remove the Back Cover (page 2-4).
Part B
Release the levers on the two ends of the DIMM slot. As you do so,
the module will rise slightly and remove the seated DIMM, one at
a time.
R
EMOVING THE
DIMM
S
F
IG
. 2-5
I
NSTALLING
DIMM
S
1. Insert a DIMM in either slot at about a 20 o angle. Grooves on the
sides of the module allow you to insert it only one way. Make sure
it is seated as far into the slot as it will go. DO NOT FORCE IT. The
module should fit in without much pressure. If there is a lot of re-
sistance, check to make sure the DIMM is properly seated.
2. Click in the slot levers to secure the module.
3. Reinstall the Back Cover.
!
Memory Upgrade Note:
• If you have changed the memory configuration, run SCU so the new total can be registered in the CMOS.
• If you have increased memory, check to see if you need to recreate the Hibernate-specific file if the system runs Windows
98 SE with Hibernate support enabled. (Refer to
Chapter 3, Advanced Controls & Chapter 5, Drivers & Utilities of the User’s
Manual for details.)
I
NSTALLING THE
DIMM
S
F
IG
. 2-6