Clevo LP200C, Руководство по обслуживанию

Страница: 25 / 104

2 – 7
D
ISASSEMBL
Y
2. D
ISASSEMBLY
M
EMORY
M
ODULE
R
EMOVAL
R
EMOVING
DIMM
S
Part A
Remove the Back Cover. (page 2-4)
Part B
Release the levers on the two ends of
the DIMM slot. As you do so, the mod-
ule will rise slightly and remove the
seated DIMM, one at a time.
R
EMOVING THE
DIMM
S
F
IG
. 2-5
I
NSTALLING
DIMM
S
1. Insert a DIMM in either slot at about a 20 o
angle. Grooves on the sides of the module
allow you to insert it only one way. Make sure
it is seated as far into the slot as it will go.
DO NOT FORCE IT. The module should fit in
without much pressure. If there is a lot of
resistance, check to make sure the DIMM is
properly seated.
2. Click in the slot levers to secure the module.
3. Reinstall the back cover.
I
NSTALLING THE
DIMM
S
F
IG
. 2-6
F
Memory Upgrade Note:
• If you have changed the memory configuration, run SCU so the new total can be registered in the CMOS.
• If you have increased memory, check to see if you need to recreate the Hibernate-specific file if the system
runs Windows 98 SE with Hibernate support enabled. (Refer to
Chapter 3, Advanced Controls & Chapter 5,
Drivers & Utilities
of the CD-based complete
User’s Manual
for details.)
DIMM Removal & Installation