Copyright © 2011 Clever Home Pty Ltd 20 Boronia Avenue Croydon South VIC 3136 ABN89088227865 Fax 9733 1254 Ph 9722 9210 [email protected]
www.cleverhome.com.au
CLEVER
HOME
®
CH00652a 23/10/2011
Schneider Clipsal
C-Bus Home Automation
Wiser IP Camera Guide
Video Encoding.
This camera simultaneously supports the generation of single JPEG frames without
authentication (as required by the Wiser Home Controller, and also viewable by
Sony PS3 browsers, free Android tablet IP camera viewing apps, etc), and MJPEG
or MPEG4 video encoding as well. Note the following about video encoding:
●
When the video encoding is set to
MJPEG
and resolution is set to the
maximum
SXGA
, still images appear best on the Wiser Home Controller IP
user interface, but live and recorded video may support lower than maximum
frame rates.
●
When the video encoding is set to
MPEG4
and resolution is set to
XGA
, still
images are naturally of lower resolution than for SXGA on the Wiser Home
Controller, but live and recorded video supports higher frame rates.
●
The address required by the Wiser to access the single frame JPEG output
from the camera is
http://
xxx.xxx.xxx.xxx
/image/jpeg.cgi
, where
“xxx.xxx.xxx.xxx” is the IP address you assign the Wiser IP Camera.
●
Use a
32 Bit Internet Explorer Browser
on a Windows 7 PC to access all
functions on the camera's own IP interface correctly.
Sensor Resolution.
This camera supports three possible video output resolutions:
●
VGA,
640*480
pixels, with motion detection.
●
XGA,
1024*768
pixels, with motion detection, MJPEG or MPEG4.
●
SXGA,
1280*1024
pixels, without motion detection, MJPEG only.
Motion Detection.
XGA (or VGA) resolution must be selected on the Camera's Browser Setup page,
otherwise motion detection is not able to be supported.
The area of the image in which motion is detected can be defined by drawing red
squares on the image in the Motion Detection GUI (see Figure 1 Below). The
motion detection area
may be irregular - it is not confined to a large rectangular
area. For outside images, the motion detection area should avoid not only plants
that may sway in a breeze, but also shadows from larger trees that may appear on
the ground on sunny days.
Sensitivity of movement detection in the red area may be set from 0% (minimum)
to 100% (maximum) sensitivity.
Remember to click “Save” at the bottom after making any changes, an allow 1-2
minutes for the camera to re-boot.
2/4
