Clever Audio 1050035, Руководство пользователя

Страница: 6 / 8

Sahara Presentation Systems Plc Williams House, Hailey Road, Erith Kent DA18 4AA
OPERATING INSTRUCTIONS
Turn the volume control to it’s off position.
Switch on the power using the on/off switch on the Active speaker rear panel.
Adjust the volume control to increase the output sound level to your preferred level.
WARNING: Always turn the unit on and wait for a moment before turning the volume
control up. High signal levels can damage the system on startup.
The system accepts line-level audio signals from sources such as PC’s, notebooks, CD/DVD
players, disc players, iPod, amplifiers, tuners etc
After use, turn off the volume control which disconnects the amplifier, and turn off the power
switch on the rear plate turning of the internal power supply.
TROUBLE SHOOTING
If the system is not operating correctly, please check the table below: If the problem persists
contact your AV reseller immediately and disconnect the system from the power.
PROBLEM CHECKS TO BE MADE
No sound from Passive speaker
• Check that the mains supply is switched on at
the wall socket
• Check that the power switch at the amplifier
rear panel of the active speaker is switched on
• Check that the volume control is turned up
• Check that the audio cables to your audio
source are connected properly
• Check that the audio source is active and
playing
SPECIFICATIONS
• Check the mini jack cable connection at the
active speaker and the connection at the passive
speaker end
Output Power 15 Watts x 2
Drive Units 4” x 2 + 1.5” x 2
Impedance 6 Ohms
Frequency Response 80Hz~20kHz
Separation >35 dB
Signal/noise ratio >60 dB
Distortion THD <0.3%
Dimensions (mm) 130 x 142 x 250 mm (L x W x H)
Power Supply 230 Volt/50Hz
No sound from either speaker