6
Operating Instructions and Owner’s Manual
Cleveland Iron Works Wood Pellet Fire Stove
UNPACKING & ASSEMBLY
1. Remove heater from carton.
2. Remove all protective packaging applied to heater
for shipment.
3. Check heater for any shipping damage. If any
damage is found immediately contact the
manufacturer at 800-251-0001.
CAUTION: DAMAGED PARTS MAY
COMPROMISE SAFE OPERATION.
•
DO NOT INSTALL INCOMPLETE COMPONENTS.
•
DO NOT INSTALL SUBSTITUTE COMPONENTS.
•
DO NOT INSTALL DAMAGED COMPONENTS.
4. Some components are packaged unattached from
the stove in order to ensure their safety during
shipping. Please find the protective packaging, likely
inside the stove door, to proceed with assembly.
Main Power Cord
The main power cord attaches to the stove at the
exposed socket in the rear of the stove. Once any
necessary assembly of the display panel screen is
complete (PSBF66W only) you may briefly plug your
stove in make sure that it functions properly before
proceeding with installation. Unplug the stove once
you confirm that the display panel works.
CAUTION: DO NOT LEAVE THE STOVE
PLUGGED INTO ANY ELECTRICAL SUPPLY
DURING ASSEMBLY OR INSTALLATION.
Firepot
With the stove unplugged from any power supply, the
firepot should be inserted into the stove so that it is
securely positioned and also the hot surface igniter
should be able to make physical contact with pellets
that would be held in the firepot. See figure 2 or 3.
Figure 2
PS60W and
PS130W firepot
41
Figure 3 P
SBF66W
firepot
A cleaning kit is also packaged which facilitates safely
cleaning the firepot perforations of debris.
Air Intake Kit
Locate the air intake kit packaged with the stove. See
Figure 4. Take measurements of your space and plan
for the installation of horizontal venting to the outside
as may be required per recommendations in “FRESH
AIR AND VENTILATION REQUIREMENTS 1” on page
7. Follow all ventilation requirements and guidelines
specified in “INSTALLATION” on page 6.
Termination Cap
2” Flex Hose
Hose Clamp
Figure 4
Intake Kit
Additional Assembly PS60W, PS130W
•
The door handle: open the door, and screw the
plastic grip onto the thread of the handle
.
Figure 5
Door Handle
Additional Assembly PSBF66W
•
The display panel: insert the display panel into the
top and rear of the stove. Be sure that the display
panel screen is facing towards the front of the stove.
Secure the screen using two of the provided screws.
•
The power cord for the display panel
:
this cord
should be wrapped up near the top of the stove.
Insert free end into the back of the display panel
(see figure 16 on page 14). This wire should
already be connected to the stoves power board. This
connection can be checked behind the access plate at
the bottom and rear of stove .
INSTALLATION
WARNING: WHEN THIS STOVE IS NOT
PROPERLY INSTALLED, A HOUSE FIRE MAY
RESULT. TO REDUCE THE RISK OF FIRE,
FOLLOW THE INSTALLATION INSTRUCTIONS.
CONTACT LOCAL BUILDING OR FIRE
OFFICIALS ABOUT RESTRICTIONS AND
INSTALLATION INSPECTION REQUIREMENTS
IN YOUR AREA.
WARNING: When this stove is not properly installed, a
house fire may result. To reduce the risk of fire, follow
the installation instructions. Contact local building or
fire officials about restrictions and installation inspec-
tion requirements in your area.
