GAS
ELECTRIC
COLD WATER
CLEARANCE
DRAINAGE
1
1
⁄
4
˝ IPS line size,
3
⁄
4
˝ (13mm) connection
120V-1Phase, 60 Hz.
35 psi minimum
RIGHT = 12.00˝
1
1
⁄
2
˝ dia.
NATURAL
PROPANE
BTU
2 Blowers & Controls
60 psi maximum
LEFT = 3.00˝
Do not connect other
Piping
3
⁄
4
˝ N.P.T.
Piping
3
⁄
4
˝ N.P.T.
35,000 each
150 watts each
C2
3
⁄
8
˝ dia. NPT for Generator
REAR = 3.00˝
units to this drain
Supply pressure
Supply pressure
Generator,
C1
3
⁄
8
˝ dia. NPT for Condenser
Allow 6˝ space min.
4.50˝ W.C. Min.
11.00˝ W.C. Min.
70,000 total
from rear and sides
Drain must be vented
14.00˝ W.C. Max.
14.00˝ W.C. Max.
When located near
combustible walls
Do not use PVC pipe
Manufacturer must be notified if unit will
be used above 2,000 feet
(NOT TO SCALE)
SECT.
IV
PAGE
12
0402
Litho in U.S.A.
Each Compartment has Capacity for:
• Three 2
1
⁄
2
˝ x 12˝ x 20˝ Steam Table Pans
• Six
1˝ x 12˝ x 20˝
Steam Table Pans
• Two
4˝ x 12˝ x 20˝
Steam Table Pans
C
NOTES:
Cleveland Range reserves right of design improvement or modification, as warranted.
Many regional, state and local codes exist and it is the responsibility of the owner and installer to comply with the codes.
Cleveland Range equipment is built to comply with applicable standards for manufacturers. Included among those approval agencies are UL/NSF#4 and CSA (AGA, CGA).
D
WATER QUALITY
REQUIREMENTS
The quality of water varies
greatly from region to
region. Steam equipment
generators must be
drained daily and chemi-
cally descaled periodically
to ensure proper operation.
To minimize service prob-
lems caused by the accu-
mulation of minerals and
chemicals in water review
the following quality guide-
lines with a local water
treatment specialist. Inlet
water that is beyond these
specified guidelines should
be treated to achieve these
acceptable limits.
Total
Dissolved Solids less than
60 ppm, Alkalinity less than
20 ppm, Silica less than 13
ppm, pH factor greater
than 7.5, Chlorine less
than 30 ppm.
Right - 3”, Left - 3”,
Rear -3”
(12” on control side if
adjoining wall or
equipment is over 30”
high for service access)
Contact factory
for variances to
clearances.
