Cleveland Steel Tool Handy-Mag II, Руководство пользователя

Страница: 4 / 15

2
Handy-Mag
II
SAFETY PRECAUTIONS
1. The operator of this machine should thoroughly understand this manual before starting
any operation.
2. The area around the machine should be well lit, dry, and free from obstructions.
3. Wear eye and ear protection at all times.
4. All maintenance and repair work should be performed by a person familiar with the
machine.
5. Do not use Handy-Mag II drilling machines on surfaces or materials being welded.
Doing so can damage the machine’s electrical components.
6. Disconnect the power from the machine before performing any maintenance or repair
work. Turn power switch to the OFF position when changing tooling.
7. Always disconnect from the power source before moving. Be sure switches are off
before connecting to a power source.
8. Magnet will not hold properly on thin materials (under 3/8”) or rough and dirty surfaces.
9. Always use safety chain and chip shield provided with machine.
10. Assure all tooling is properly held in position before starting any operation. Periodically
check all tooling for tightness.
11. Do not use dull or broken cutters.
12. Keep tools sharp and clean for better and safer performance. Follow instructions for
lubricating and changing accessories. Inspect tool cords periodically and if damaged,
have repaired by authorized service facility. Inspect extension cords periodically and
replace if damaged. Keep handles dry, clean and free from oil and grease.
13. Beware of slugs ejected at end of cut. They become HOT during the cut.
14. Keep bottom of magnet burr free and clear of chips and debris.
15. Drilling stacked material requires a special STACKED GEOMETRY cutter.