Clemas & Co TITAN 95 BF 68 OL, Руководство оператора

Страница: 10 / 23

10 English
5. TROUBLESHOOTING
5.1 No water is delivered.
- Check the water pump fuse.
- Turn the delivery knob clockwise.
- Clean the filter in the water tank.
- Fill the clean water tank.
- Check feed pipes for kinks.
- Check operation of the pump.
5.2 The vacuum motor does not start.
- Check the vacuum motor fuse.
- Clean the dirty water tank around the sensor electrodes and the
electrodes themselves.
- Do not move the electrodes from their original position; make sure they
are not out of position.
- If the distance between them, or between the electrodes and the side
of the tank, is modified, the power cut-off mechanism may be activated
by mistake.
- Observe how much foam is generated by the detergent used.
- Use Gansow´s low foam detergent.
5.3 Water is not sucked up, although the vacuum motor is operating.
- Make sure the drain hoses are closed.
- Check the tank lid is properly in place and lying flat on the water tank.
- Check the state of the tank gasket. Replace if necessary.
- Check the state of the squeegee blades (see also points 5.4 and 5.5)
- Check that the suction tubes leading from the squeegee to the dirty
water tank and the connectors inside the dirty water tank are not
blocked.
5.4 The squeegee with suction is leaving smears.
- Clean the rear squeegee blade.
- Check the rear squeegee blade and if necessary turn or replace. The
rear squeegee blade may be used four times.
- See also 5.8.
- Use the wheels to adjust the height of the squeegee from the ground.