Clemas & Co CS220 140B, Руководство оператора

Страница: 15 / 31

TECHNICAL DATA
S32B
Revision 00 Maggio 2006 Page 17 di 37
The operator has to follow the rules below to sweep the surface:
¾
start and sink the sweeping group down;
¾
start the vacuum engine;
¾
open the flap;
¾
drive the sweeper at the same speed to clean all the surface.
The operator has to follow the rules below to empty the waste tank:
¾
close the flap;
¾
start the filter shaker to clean the vacuum filter;
¾
lift the waste tank up;
¾
open the flap, let the dust fall down from the waste tank and start the filter shaker again to clean the
vacuum filter ;
¾
keep away from the waste tank and make sure that nobody is near the sweeper. Sink the waste
tank down.
Main brush replacement
The operator has to follow the rules below to replace the main brush:
¾
by means of the lever (see picture n. 10) open the little door on the right side of the sweeper;
¾
unscrew the bolts (see detail 1 in picture 10) that hold the rubber catch sheet;
¾
remove the sheet;
¾
remove the dust cover rubber;
¾
unloose the knob and open the door that holds the brush (picture 11);
¾
remove the brush (picture 12);
¾
set a new brush up and check its holders;
¾
follow now the opposite operations.
Picture 10
Detail 1
Dust cover rubber