Page 6
PL12EN-TVP100
03/07/2013
1
Getting Started
1.1
Safe Work Practices Symbol
This “Warning” symbol identifies all notes on safe work practices in this operating
instruction, alerting to hazards for life and health of people. Please observe these
notes and proceed with special care in the cases described. Pass all safety
instructions on to other operators. In addition to the safety instructions in this operating
instruction, the general local safety and accident prevention rules must be observed.
The signal word “Caution” identifies all portions of this operating instruction
meriting special attention to ensure that guidelines, rules, hints and the correct
work procedures are observed; and, to prevent damage to and destruction of
the machine and/or parts.
1.2 Transportation
This unit does not require any special transportation instructions.
1.2.1 Unpacking
This unit does not require any special unpacking instructions.
1.2.2 Checking Your Unit
Take the time to ensure that you have the required peripheral equipment and cables
necessary to setup and run your unit. If you do not have all the necessary items, please
contact your distributor.
1.3 Software
Your unit has been pre-loaded with its software and requires no additional software to
start monitoring your fastening process. If you are trying to interface this unit to an exter-
nal computer, additional software may be required. Please contact your distributor with
inquires about interface software.
1.4 Installation Of The Unit
1.4.1 General
It is mandatory that national, state, and local safety and wiring standards
be followed during installation. These standards would take precedence
over any information presented in this section.
To avoid the hazard of electrical shock or burn, the following instructions must be
adhered to. Failure to follow these instructions may also cause damage to your
unit and void existing warranties.
Do not energize the unit until all connections have been properly made.
•
Equipment must be properly grounded before applying power. Units energized
•
by cord and plug must be connected to an approved and properly grounded
receptacle.
Ensure the power switch is in the “off” position before applying power.
•
Cleco
®
Pneumatic Torque Verifier TVP-100 Series
