8
P2332BA | 2019-08
Apex Tool Group
3
EN
3.3.1 On/Off button
3.3.2 Function keys
Left function key <F1>
Right function key <F2>
3.3.3 LCD
Information and the menu and submenus are displayed on
the LCD (Liquid Crystal Display).
See chapter
3.3.4 LED display
The LED display shows the operating status and the con-
nection status:
Software update
During a
Software Update
, the actual programming pro-
cess is indicated by alternating red and green flashing at
irregular intervals
.
3.3.5 Status LED
The status LEDs allows the operator to see which socket is
to be used.
The color of the status LEDs can be individually pro-
grammed. This depends on the software used on the con-
troller. Further information is described in the programming
instructions of the respective software.
3.3.6 LiveWire Memory Chip (LMC)
To permit simple replacement of socket trays in production,
a replaceable LMC memory module is installed. When the
socket tray is switched on, the network settings are read
from the LMC chip and used to set up the WLAN connec-
tion. When the socket tray are changed, the LMC has to be
installed in the new socket tray being used.
The following data are stored on the LMC:
The MAC address is defined by Cleco Production Tools
and cannot be changed. The other data can be changed
with
LiveWire RF Configuration
software via
USB connection to the PC.
3.3.7 Wireless module
The
socket tray is equipped is using a WLAN Stan-
dard: 802.11a/b/g.
3.3.8 Extension board
The number of expansion boards depends on the socket
tray.
Press the on/
off button
Function
Press once
•
Switch the socket tray on
•
Switch from the main menu to the
submenu
Press for two
seconds
•
Switch the socket tray off.To do
this, the system must be outside
the main menu and the sub-
menus.
Press <F1>
Function
Press once
•
Switch to the previous menu item
•
Quit the LED and Initiator
test
Press for two
seconds
•
Switch to the next higher menu
level
Press <F2>
Function
Press once
•
Switch to the next menu item
Press for two
seconds
•
Select functions, if menu is acti-
vated
LED display
Operating sta-
tus
Connection sta-
tus
Continuous
green light
Active
Active
Flashing red
light
Faults
Flashing red
and green
light
Flash twice after
switching on and
during the lamp
test
Green off
No connection
Red off
No error
Do not interrupt the software update by
disconnecting the power supply during
this phase.
•
MAC address
•
Network name (SSID)
•
Encryption
•
Network key
•
Use of the DHCP
server
•
IP address
•
Subnet mask
•
Gateway
•
Country-specific set-
tings
Socket tray
Number of extension boards
943620PT
1
943610PT
2