30
P2544PM | 2021-02
Apex Tool Group
3
EN
3.8.1
Speed test
The speed measurement is based on the angle information from the motor. If the start button is released,
the tool stops. As a safety function, the torque is monitored by the tool transducer. If it exceeds 15% of its
calibrated value, the speed measurement is terminated.
To start the tests, keep the Start switch pressed.
>
Fig. 3-24: Submenu – Speed test
Torque test
Calibration value
Voltage
Counters status
Tool constant
If an accessory is used, one of the buttons is displayed depending on the type:
•
2D Reader
•
Gyroscope
•
Accessory is not detected.
Perform software update with a newer software version. The latest software
version can be found at:
https://software.apextoolgroup.com
Button
Description
123
Symbol
Description
Keep the Start switch pressed.
→
The tool runs at maximum speed.
→
The current speed is displayed.
400
