Cleco 936400PT, Инструкция по эксплуатации, Страница: 26 / 78

26 P2070BA/EN 2011-06
70b_1_5 en.fm, 12.03.2015
Troubleshooting
6
6 Troubleshooting
7 Service

Keep contacts free from contaminations. This is the only way to ensure smooth functioning.
8 Maintenance
NOTE
If repair is required, send the complete battery to our Sales & Service Center!
It may be repaired only by authorized technicians. Opening the battery will void the warranty.
9 Technical data
Problem Possible cause Measure
Expected number of test
rundowns is not
achieved with one
charge of the battery. Battery is not fully charged.

Use fully charged battery.
The warning threshold for undervol-
tage is not set to minimum value.

Set the undervoltage to 37,2 Volt
using the control on the
tool
screen.
A high torque was required for the
rundowns, e.g. for coated screws or
for several revolutions.
Using a high torque for a longer
period of time will reduce the number
of rundowns to be achieved with one
battery charge.
Battery has too many charging
cycles. After 800 charging cycles the capac-
ity is reduced to approx. 60%.
No LCD display Battery is in Deep Sleep Mode

Recharge battery with charger
Battery is defective

Replace battery
Changing LCD display Battery temperature is > 118.4° C

Leave the battery to cool. Display
expires.
Battery detecting short-circuit

Remove short-circuit.

Push battery on to battery
charger. This will reset the error
message.
Charger indicates bat-
tery fault Battery is defective Replace battery
Features Data
Battery type Lithium ions (Li-Ion), 12 cells
Nominal capacity 1650 mAh / 72.6 Wh
Rated voltage 44.4 V
Maximum voltage 50.4 V
Battery self-discharge
1
:
Default settings
Fully charged 100 days
360
days
Weight 850 g
EN