Flash Codes
Scooter Controller Internal Diagnostics
The diagnostic flash codes for your scooter are designed to help you perform basic
troubleshooting quickly and easily. A diagnostic flash code flashes from the Power
light in the event one of the conditions listed below develops.
Flash
Code
Fault
Consquences
for
Scooter
Solution
1
Battery charge is
too low
Scooter
continues to
drive.
Charge batteries.
2
Battery charge is
depleted
Scooter stops
driving
Charge batteries.
3
Battery voltage is
too high
Scooter stops
driving
If the charger is connected, disconnect
it from the scooter.
The electronic system charges the
batteries when running downhill and
when braking. This fault is caused when
the battery voltage becomes too high
during this process. Switch the scooter
off and on again and if travelling
downhill reduce speed to the minimum
setting.
4
Power time
exceeded
Scooter stops
driving
The maximum current has been
exceeded over too long a period,
probably because the motor has been
overloaded. Switch the
scooter off for a few minutes, then turn
back on again.
5
Break error
Scooter stops
driving
Ensure the manual freewheel lever
is in the drive position and restart the
scooter.
There is a fault with the magnetic
brake or wiring – contact your
authorized dealer of assistance.
32