A
Installation
Dimension
2 - 2
To remove the cartridge.
First shut off the water supply to the tap.
1: Pull out the cap from the handle.
2: Loosen the grub screw in handle, but do not remove it.
3: Take off the handle, unscrew the cartridge cover.
4: Using a correct size spanner unscrew the retaining nut.
5: Pull the cartridge and wash it with clean running water.
6. Dry and lightly grease the seals (only use silicone grease)
7: Replace them in turn.
MIXER BODY
CARTRIDGE
RETAINING
NUT
CARTRIDGE
COVER
HANDLE
ALLEN
KEY
GRUB
SCREW
CAP
2-G3/4
197
108
Ø28
166
Ø55
Ø55
35
99
154
22
Max30
FLEXIBLE PIPES
LEFT: HOT FEED
RIGHT: COLD FEED
FIXING NUT
HANDLE
NOZZLE
MIXER BODY
WASHER
1: Fit the washer into the groove in the underside of the mixer body.
2: Screw the flexible pipes into the mixer body, and fully hand tighten.
3: Pass the tail of flexible pipes through the hole on the bath from above, and place the mixer in position on the bath, to see if any
alteration to the existing supply pipe work is necessary, make any necessary alterations to the pipe work.
4: Slide the fixing nut up the tails and onto the fixing bolt.
5: Check that the mixer body is correctly positioned, fully tighten the fixing nut.
6: Connect the water supply pipe to the tail of flexible pipes with the hot water on the left and cold water on the right.
