9
CLEARSPAN
™
CARPORTS
Revision date: 04.27.09
END RAFTER ASSEMBLY (2)
Gather the parts:
• Pipes 1.90" x 96" plain (190P096)
• Pipes 1.90" x 203.25" plain (190P20325)
• 3-way couplers (#107623)
• 4-way couplers (#107622)
•
10015108 fittings
• Fabric clips (#CC6214) & 5/16" Hex key wrench
NOTE
: Assistance is required to assemble the shelter.
1. Select the four (4) pipes needed to assemble each
end rafter and arrange on the ground adjacent to the
correct couplers shown below.
2. Connect 3-way couplers (#107623) to the pipes shown
below to form the end rafters.
NOTE:
Attach one fabric clip (CC6214) to one end of
each 1.90" pipe and insert the end with the clip into the
3-way couplers (end rafters) or 4-way couplers (interior
rafters).
To prepare each frame pipe, slide a pipe into the
required coupler,
draw a line on the pipe
to mark
the coupler position, and remove the pipe. Take one
CC6214 clip and snap it onto the pipe end just above
the mark. Insert the pipe end with the clip into the
coupler, align the clip with the locking screw, and
tighten the locking screw against the clip.
3. Slide one tee coupler (#10015108) onto each end rafter
leg. Tighten the Allen screws to secure the coupler to
the leg pipes.
Position the Allen screws to the inside of
the frame
.
4. After the end rafters are assembled, continue with the
Frame Assembly
instructions that follow.
Leg
(#190P096)
Leg
(#190P096)
Leg
CC6214
#107623
Step 2
Rafter Pipe
(#190P20325)
Rafter Pipe
(#190P20325)
#107623
Pipe with
fabric clip
#107623
Rafter Pipe with fabric clip
Allen
Screw
#10015108
Leg
Step 3
NOTE:
Frame shown may differ in length from actual frame.
