ClearSpan 105624, Руководство пользователя

Страница: 7 / 23

7
CLEARSPAN
™
CARPORTS
Revision date: 10.27.08
LAY OUT THE BUILDING SITE
The Low-Profile Roof Frame is designed to be secured
to a permanent structure, or to 4" x 4" posts anchored in
the ground. ALL DIMENSIONS REGARDING THE ROOF
FRAME ARE CENTER-TO-CENTER .
ATTENTION: The customer is responsible for providing
the support structure for the frame. Consult a professional
contractor if needed to construct the required support
structure.
Verify that the support structure complies with local and
regional building codes before construction.
After the support structure for the low-profile roof frame
is constructed, continue with the RAFTER ASSEMBLY
procedures that follow.
ASSEMBLING THE LOW PROFILE ROOF FRAME
COMPONENTS
NOTE
: Assistance may be required to assemble the Low
Profile Roof Frame.
RAFTER ASSEMBLY
Gather the Parts:
• Rafter Pipe (#18CP20P3)
• Rafter Pipe (#S20P048)
• Rafter Pipe (#12RF20P1) and Post Caps (#105560)
• 3-Way Square Tube Fittings (#104626)
• 4-Way Square Tube Fittings (#104627)
• Tek Screws and Nut Setter 3/8'' x 2-9/16 Magnetic
Rafter Assembly Procedure:
Each rafter assembly consists of five (5) rafter tubes:
one (1) curved center pipe (for the top or peak), two (2)
extension pipes and two (2) lower bent leg pipes.
NOTE:
The end rafter tubes are connected using 3-Way
fittings; the interior rafter tubes are connected using 4-Way
fittings. See the following diagram and the Connections
Diagram for clarification and tube locations.
All rafters include two (2) post caps to attach the
assembled rafter to the support structure.
End Rafter Assembly:
Complete the following steps to assemble the two (2) end
rafters.
NOTE: The two (2) end rafters are assembled using 3-Way
fittings positioned between the upper tube splices.
1. Select the three (3) pipes needed to assemble the end
rafter. Refer to rafter assembly diagram.
2. Brace the rafter pipes and insert the 3-Way fittings into
the rafter pipes and secure them using Tek screws.
ATTENTION: All the 3-Way fittings should face the
same direction. The free section of the tube fitting is
used to connect the purlin pipes.
Install 3-Way fittings in the locations shown above. End
rafters only.
IMPORTANT: To prevent damage to the cover, the Tek
screw heads must not come in contact with the cover
when installed.
3. Repeat above steps for the remaining end rafter.
NOTE:
There are only two (2) end rafter assemblies.
Rafter Pipe
3-Way Fitting
Tek Screw
Rafter Pipe
Tek Screw
(#12RF20P1)
(#105560)
(#S20P048)
(#18CP20P3)
(3-Way)