PARTS CHECKLIST
CORDLESS
HANDSET
AC ADAPTER
CARRYING CLIP
BATTERIES
PHONE BASE
USER’S MANUAL
CONNECTING YOUR PHONE
LOCATION OF CONTROLS
1. CHECK
PARTS LIST
2. PHONE INSTALLATION:
The phone should be located
in an area where it is easy to see the visual display and
lighted ringer. The phone may be placed on a shelf or table
or may be fixed to the wall.
Begin by removing the clear
plastic Caller ID protective tab. This film tab is only
for display and to protect your Caller ID display during
shipping.
Desk / Table Mounting
1. Plug the AC power adapter into the
jack on the bottom of the base,
then plug the AC adapter into a
standard electrical outlet or
surge protector.
NOTE
: The adapter is required for
the phone to work.
Installing Batteries
Three AAA re-chargeable Ni-MH
batteries come with your phone. You must install the
batteries before using your phone.
1. Remove the battery compartment cover by sliding it
downwards.
2. Insert the new batteries. Be sure to observe
battery polarity as imprinted on the inside of the
compartment.
3. Replace the battery compartment cover by sliding
upward until it clicks into place.
NOTE:
The batteries need to be replaced if they do not
recover their full storage capacity after recharging. Check the
battery icon on the LCD to see the battery charge level. When
replacing the batteries, always use good quality Ni-MH AAA
re-chargeable batteries.
If at any time you have questions about your
telephone after reading this manual, please
contact our ClearSounds
®
Customer Service
Department at 1-800-965-9043.
Figure 1
1 Visual Phone Ringer
2 (4) 1-Touch Memory
Dial
Keys
3 Large LCD/Caller ID Screen
4 Right Soft Key
5 Right/Redial Key
6 End Key
7 Down/Phonebook Key
8 Hash (Pound) Key
9 Microphone
10 Star Key
11 Lighted Keypad
12 Dial/Speakerphone Key
13 Left/Intercom Key
14 Left Soft Key
15 Up/Caller ID Key
16 Earpiece
17 Carrying Clip
18 Speaker
19 SOS Key
20 Screw Eye
21 Battery Compartment
Cover
22 Charging Contacts
1
2
3
7
8
6
4
9
5
10
11
12
13
14
15
16
17
19
18
20
21
22
Bottom of base
REGISTERING ADDITIONAL HANDSETS
The supplied handset is already registered to the base unit,
and you can register up to 4 additional handsets to the base.
1. Before registering an additional handset to the base, you
should press and hold the page key
, which is located
on the main base, for about 5 seconds and then release it.
2. Press the
Menu
soft key on the handset you are registering
to display the main menu list.
3. Press up
or down
to scroll to
Registration
and then
press the
Select
soft key.
4. Press up
or down
to scroll through the base list and
select one of the bases and then press the
Select
soft key.
The handset will search for the requested base.
5. If the handset is successfully registered, you will be
prompted to enter the PIN code (the default PIN is 0000).
Upon validation of the PIN, the Registration tone will
sound and the base assigns a number to the handset.
More information on this feature located in the Operating
Manual on page 17.
Dialing from the Memory M1 – M4 and SOS keys
Press one of the
M1 – M4 or SOS
memory dial keys and the
phone will automatically begin to dial (Page 30 of the Operating
Manual describes how to program the memory dial keys).
MEMORY KEYS
