QUICK-START GUIDE
7
The terminal block pins are numbered from left to right 1, 2, 3, 4, 5 and 6.
The pins 1 and 3 are the inputs used to select different pairs of channels.
Channel selections are made by connecting combinations of pins 1 and
3 to pin 6. Pins 2, 4 and 5 must not be used to avoid equipment damage.
All E-bus signals will pass through the CONVERGE USB, but only the
selected Tx/Rx channels will be used by the CONVERGE USB.
The following illustration show the possible pin/channel selections using
jumper wires on the terminal block:
Tx channel - K
Rx channel - L
Tx channel - M
Rx channel - N
Tx channel - O
Rx channel - P
Tx channel - Q
Rx channel - R
No
Connector