CONNECT NETwOrk BridgEs
QuiCk-sTarT guidE
2
3
QuiCk-STArT OvErviEw
Installing and using the CONNECT Dante bridges in your CONVERGE
Pro/SR site is subject to the following rules:
1. The CONNECT Dante can only be used with CONVERGE Pro/SR
systems operating at version 4.3.X or greater, and requires that the
firmware on the CONVERGE Pro/SR be updated.
2. You must have a CONVERGE Pro 840T, 880, 880T, 880TA, 8i, TH20,
VH20 and/or SR1212, SR1212A in the site.
3. The CONNECT Dante bridge can only interface with the Dante
network architecture, but can operate in sites including CONNECT
CobraNet™ bridges.
Quick Start Summary
These steps must be done
in the following order
to use the CONNECT
network audio bridge in your CONVERGE Pro Site:
1. Update the CONVERGE Pro Software to version 4.4.X using the
software installer version 4.5.X.
2. Update the CONVERGE Pro firmware to version 4.3.X using
CONVERGE Console.
3. Update the firmware of all devices on the site to 4.3.X. (CONVERGE
Pro units, Beamforming Microphone Arrays, CONNECT CobraNet,
etc.)
4. Set the Device ID of the CONNECT Dante network audio bridge
using the Device ID rotary selector switch at the back of the device.
5. Connect the CONNECT Dante network audio bridge to the updated
CONVERGE Pro/SR via the Expansion bus (E-bus).
6. Configure the CONNECT Dante bridge with CONVERGE Console.
7. Configure the Dante network using the Dante Controller software.