Operation Guide For A Clearlite Spa Bath
(Hydro or Whisper Jets)
When filling the bath it is recommended to partially fill with cold water to allow the bath to gradually adapt to the
temperature. Also the heated pump features a safety protection device, which cuts out the heater if water
temperature exceeds 50 degrees.
Electronic Touch Pad
For the pump and heater to operate the
Power
light on the
control touch pad must be on.
Pushing the
Spa
button will start or stop the pump and heat
together.
The
Eco Heat
button enables the heater to be turned off/on
while the pump continues to operate
.
Air Controller (Hydro and Mini Jets Only)
Opening and closing of the air controller determines the
amount of air drawn into the jet stream.
When the controller is open the jet is drawing maximum air
creating a vigorous massage.
When the controller is closed, only water comes through for a
gentle soft massage.
Hydro Jet Option
These jets can be adjusted to suit individual preference.
To adjust the direction of the jet, use the tip of your index
finger on the edge of the eyeball to change direction or
angle.
To obtain maximum water flow, turn the jet face clockwise.
To obtain minimum water flow, turn the jet anti clockwise.
Whisper Jet Option
These jets are designed to create a flow of water and small
bubbles down under the bather. This creates a light soothing
massage without the direct force of a hydro jet.
The jets are not adjustable.
To remove the jet cover, push a thin piece of wire into the hole
located near the top of cover and then slide the cover up. To
refit, slide the cover down until it clips onto the jet body
Jet Options