User manual / Bedienungsanleitung
Made in Germany
Page / Seite 7
Change between
channel 1 (60Hz)/
speed 33 1/3rpm and
channel 2 (81Hz) /
speed 45rpm
ON/OFF
Power output
On = bottom pressed
Fine adjustment
of the speed
4. The left button on the front panel changes the speed between 33 1/3rpm and 45rpm.
From the factory the frequency is pre-setted:
For channel 1 (33 1/3rpm) = 60Hz
For channel 2 (45rpm) = 81Hz
5. The Clearaudio
smart synchro
allows you also to set and maintain an exact speed by using the
delivered screw driver.
For this fine adjustment you have to turn the integrated potentiometer screws in the middle of the
front panel (left for 33 1/3rpm and right for 45rpm).
6. We recommend to have enough lightness for this adjustment.
Insert the screw driver into the small pre-drilled fitting in the middle of the front panel (left side for
33 1/3rpm and right side 45rpm) until you feel a variable resistance.
Turn slowly and carefully the integrated potentiometer screw until you have the correct speed
adjustment:
Clockwise = frequency rises up
Counter-clockwise = frequency falls
7. For this fine adjustment of the correct speed
Clearaudio recommends the Clearaudio Stroboscope
Test Record (AC038) and the Clearaudio 300 Hz Speed light (Set with record: AC076), available
under: www.analogshop.de !
Attention:
If the
smart synchro
is not in use for an extended period, switch it off at the ON/OFF
bottom.
Clearaudio wishes you a lot of pleasure with your new power generator
smart synchro
!
