User manual
Made in Germany
Page 9
3.5
Remove the protecitve film from the sensor mounted in the turntable chassis.
Please remove the protective film extreme carefully and avoid any soiling and scratches.
3.6.
Using both hands, carefully take the stainless steel sub-platter out of the box.
Carefully remove the protective film from the sensor ring on the underside of the sub-platter.
Again, please remove the protective film extremely carefully to avoid any soiling or scratches.
Carefully slide the upper part of the bearing through the opening of the sub-platter and fix the upper
part of the bearing using the mounting clip supplied. The lower side of the platter with the sensor
ring must point downwards.
Pic. 7: Connection of sub-platter and bearing
3.7)
Place the sub-platter carefully and slowly on the axis of the pre-mounted magnet bearing on the
turntable chassis.
Please procced very carefully!
Make sure that the platter is positioned straight and level, so that it does not tilt and damage the
bearing while it is being placed!
Pic. 8: Placing the stainless steel sub-platter
