Avantgarde
Magnum
Bedienungsanleitung
USER
MANUAL
Seite/Page 14
clearaudio electronic GmbH 2006
3. Assembly and Operation
First please put on the white gloves to avoid finger prints on the surface of the acrylic chassis during
installation.
1. Place the chassis with the spikes upside down on
a clean and levelled surface. Now take the
turntable platter incl. the upper part of the
bearing and place it carefully on the axis as
shown in the right picture. During this procedure
please pay attention not to place any of the
grease on the acrylic surface of the chassis.
There should not be any air left inside the
bearing.
2.
The following adjustment is very important:
should the air bubble in the level gauge not be in the
black circle (see at the blow up), please ensure then that
your underground so will be according aligned. Only if the
turntable will be aligned you will receive the optimum on
sound.
3. Place the pulley on the motor spindle. The
distance between the pulley and the motor
housing should be approx. 1mm. Tighten the
little screws inside the pulley with the
aluminium screwdriver provided.
4. Take the motor and place it in the indent of the
chassis. The switch should be on the outside of
the turntable and the space between motor and
chassis approx. 1cm
