Clear-Com trilogy Mercury, Быстрый старт

Страница: 4 / 22

4 Mercury Quick Start Guide
Network plan and IP addresses
The Mercury Host will normally be connected to an IP network.
This allows it to communicate with other Trilogy IP-based
intercom products and to connect to the Gateway Configuration
Editor software. However, once correctly configured, a single
Host can operate in isolation.
Each Host requires the following IP addresses:
1. Windows OS -- the default ex-factory values are below.
2. The internal IP audio card which is set by the
configuration data.
3. Two further addresses for the internal digital signal
processing (DSP) module, also set by the configuration.
Your laptop or PC must use an address in the same subnet
(“range”) as the host(s). If it is not convenient to adjust the
address of your PC then the default addresses used by the host
must be changed, as described later. Make a note of the values
which you plan to use. See the next section for help with an
appropriate database location.
Any mistakes or inconsistencies in these values may lead to
unpredictable audio behaviour. For example, if you declare a
gateway address on your PC, this must also be declared within
the configuration data for the MIU Windows Host.