R M - 7 0 2 T W O - C H A N N E L R E M O T E S T A T I O N
2 - 8
You can change this option so that a
talk
signal, rather than a
call
sig-
nal, interrupts the
program
audio on channel B. You do this by re-set-
ting an internal jumper. See the next section, “Re-Setting Program
Interrupt Options,” for instructions.
The RM-702 is shipped from the factory with all DIP switches in the
off
position. To enable a function, place that DIP switch in the
on
position.
Figure 2-7: DIP switches
RE-SETTING PROGRAM INTERRUPT
OPTIONS
When you set one of the rear-panel
program interrupt
DIP switches to
on
for
a particular channel (A or B), any
call
signal activated on that channel
interupts the
program audio
during the call signal.
You can change this option so that activating a
talk
signal, rather than a
call
signal, interrupts the program audio for the duration of the signal. You do this
by re-setting an internal jumper on the station’s internal circuit board.
To re-set the program interrupt option:
1. Please observe anti-static procedures. Static electricity can damage a circuit
card. Please ground yourself and tools before touching the circuit card.
2. Remove the cover of the RM-702 by removing the eight Phillips screws.
3. On the main circuit board, locate one of the following:
•
For channel A
: The
JP5
three-pin jumper, located in the center of the
circuit board.
•
For channel B
: The
JP6
three-pin jumper, located in the center of the
circuit board.
4. A jumper plug covers two of the three pins on each jumper. To change the
program-interrupt option on your station, do one of the following:
•
For channel A
: Move the jumper plug so that it covers pins 1 and 2.
This causes
talk
signal activation to interrupt the program audio.
Momentar
y Only T
alk B
Call-on-T
alk A
Call-on-T
alk B
Interr
upt Announce
Interr
upt Exter
nal IFB
Long Line
A
Long Line B
Pro
gram Interr
upt
A
Pro
gram Interr
upt B
Pro
gram Enable
A
Pro
gram Enable B
Momentar
y Only T
alk
A
Off (Default)
On
Содержание ENCORE RM-702
Страница 1: ...RM 702 TWO CHANNEL REMOTE STATION I N S T R U C T I O N M A N U A L CLEAR COM ENCORE ...
Страница 12: ...R M 7 0 2 T W O C H A N N E L R E M O T E S T A T I O N 1 6 ...
Страница 29: ...R M 7 0 2 T W O C H A N N E L R E M O T E 2 1 7 Figure 2 14 Connecting Party Line Products As Program Sources ...
Страница 34: ...R M 7 0 2 T W O C H A N N E L R E M O T E S T A T I O N 3 2 ...
