Clear-Com CELLCOM 10, Инструкция по эксплуатации

Страница: 68 / 168

Vitec Group Communications
CellCom-10 Instruction Manual
5 - 1 2
In some cases, the audio paths must be re-made before the changes
will take effect.
SELECTING PARTY LINE TYPE
Before enabling a party line from the base station’s front panel the type
of party line must be set on the base station so that it can set the
proper termination, gain level, and call signalling for that system.
The three types of party line systems are: Clear-Com, Drake, and RTS.
To select the type of party-line system for a party-line port
1. Select PORTS from the main menu, then select PLCHA or PLCHB
from the AVAILABLE AUDIO port menu which appears.
2. Select TYPE.
The TYPE OF PORT menu appears.
3. Select either Clear-Com, Drake, or RTS. The changes are saved
and applied automatically five seconds after the last time the
setup/enter knob was pressed or turned. The front-panel display
flashes to indicate that the changes are being saved and applied.
The base station automatically sets the port’s termination, gain, and
call signalling options for the selected party line type.
BASE STATION SYSTEM MENU
The base station SYSTEM menu offers several system-wide
capabilities, including giving information on firmware, DECT system ID,
IP address, and active antenna status, in addition to setting overall
system gain, locking the front-panel enable buttons, remote
microphone kill, and restoring the most recent downloaded
configuration.
The left and right arrows at the edges of the display allow scrolling
backwards and forwards between screens on the system menu.
From the MAIN menu, select SYSTEM. The SYSTEM menu appears
as shown in Figure 5-18.
Figure 5-18: System Menu 1
The following sections describe the items on this menu.
SYSTEM MENU
GAIN BACK INFO ANTNS
IP
DFLTS