Clear-Com CELLCOM 10, Инструкция по эксплуатации

Страница: 60 / 168

Vitec Group Communications
CellCom-10 Instruction Manual
5 - 4
6. When the desired new character appears, press the setup/enter
knob to select it. The box disappears, and is replaced by the solid
highlight.
7. Repeat steps 4 through 6 for all the characters in the label that are
to be changed.
8. When editing the label has been completed, select and then
de-select the fifth character to return to the PROGRAMMING
OPTIONS menu.
Note: The user must select the fifth character, even if it is blank,
as in a label with less than five characters.
9. The changes are saved and applied automatically five seconds after
the last time the setup/enter knob was pressed or turned. The
front-panel display flashes to indicate that the changes are being
saved and applied.
10. The beltpack that has had a new label assigned to it should be
power cycled to ensure it is updated with the new label.
To edit another beltpack label, scroll clockwise to the BACK command
and select it. The AVAILABLE BELTPACKS screen appears. Select a
new beltpack label to edit, and repeat steps 2 through 9.
SETTING AND CHANGING PORT LABELS
Port labels are created to identify the audio devices wired to the base
station’s rear panel ports, such as party-line beltpacks, 4-wire devices,
program sources, and stage-announce outputs and relays.
To create a port label
1. From the base station’s MAIN menu, scroll to and select PORTS
(see Figure 5-5). The AVAILABLE AUDIO PORTS menu appears,
as shown in Figure 5-6.
Figure 5-5: Select “Ports” from the Main Menu
Figure 5-6: Select a port from the AVAILABLE AUDIO PORTS menu
MAIN MENU
GROUPS BELTPACKS SYSTEM
PORTS
AVAILABLE AUDIO PORTS
HDSTA
HDSTA
4WIR1
4WIR1
4WIR2
4WIR2 4WIR3
4WIR3 BACK
HDSTA
HDSTA
Audio ports include headset,
4-wire, party line, stage
announce, and program
source labels.
The upper label retains the
same generic label, while
the lower label can be edited
to the user requirements.