4
CAUTION: ALWAYS UNPLUG THE APPLIANCE BEFORE YOU REMOVE
ACCESSORIES OR CLEANING OR MAINTAINING THE APPLIANCE.
MAINTENANCE
Always unplug the appliance before you remove accessories or cleaning or maintaining the appliance.
1. Always keep the machine clean.
2. Add 7.5 litres of clean warm water (below 50°C) into the clear water tank. Then start the water pump,
nozzle and sucker to run for 1 minute. This can prevent the deposit of alkali substances.
3. Wash off dirt and wool on the floating ball support in sewage tank. The wool must be thoroughly
eliminated to ensure that air flow outlet will not be obstructed.
4. Check the filter at the inlet of clear water tank for any wool or dirt. If any, remove them.
5. Clean the dirt of filter, take the filter out and rinse it with water or use a soft brush to wash it.
6. To eliminate the residual alkali liquid, please purge with vinegar solution (1:3 mixture of vinegar and
water). Purge at least every month.
7. Be sure to open the drain valve before putting the machine away for storage or when not in use.
INSTRUCTIONS FOR CLEANING FUNCTION
*** NOTE: Remember to remove the cloth filter bag from the machine when using the extraction function.
CLEANING CARPETS
When cleaning carpet, you must connect the large floor wand (see No.11 in diagram - big water sucker).
Connect the cuff end of the vacuum hose to the upper end of the steel pipe on the large floor wand, then
connect the machine end of the vacuum hose to the square connector on the tank of the machine.
Connect the male quick connector on the long solution hose to the female quick connector attached to
the handle of the large floor wand. Then connect the other male quick connector at the other end of the
long solution hose into the female quick connector located under the on/off switch.
Add 20 Litres of clear water into water/liquid tank. If carpet needs a deep clean, you can add a low foam
carpet cleaning solution into the water/liquid tank (1:12 mixture of carpet cleaning solution and water).
Turn on the pump switch and both suction switches.
Holding the large floor wand, press the trigger to release the spray onto the carpet and direct over the
area to be cleaned.
Refill the water/liquid tank as required, and empty the large tank of dirty water when it becomes full by
releasing the dirty water through the drainage hose.
CLEANING UPHOLSTERY
When cleaning smaller areas such as couches, chairs and upholstery, you must connect the small
upholstery tool (see No.14 in diagram - small water sucker).
Connect the cuff end of the vacuum hose to the steel pipe on the upholstery, then connect the machine
end of the vacuum hose to the square connector on the tank of the machine.
Connect the male quick connector on the long solution hose to the female quick connector attached to
the handle of the upholstery tool. Then connect the other male quick connector at the other end of the
long solution hose into the female quick connector located under the on/off switch.
Then follow the same steps as above to add clear water to the water/liquid tank and turn on the machine.
Holding the upholstery tool, press the trigger to release the spray and direct over the area to be cleaned.
Refill the water/liquid tank as required, and empty the large tank of dirty water when it becomes full by
releasing the dirty water through the drainage hose.