CleanStar VBRO20, Инструкция по эксплуатации

Страница: 4 / 7

4
OPERATING INSTRUCTIONS
1. Make sure that the power supply is identical to that shown on the rating label/voltage plate.
2. Insert the hose connector into the air inlet mouth
as picture shows, make sure the connector is
tightly fastened.
3. Press the connector button as picture shows
and pull the connector out when you want to pull
hose connector from this machine.
4. Connect all the accessories as picture shows:
5. Insert the plug into the supply socket.
6. Press the ON switch button to start the machine.
7. You can adjust the airflow by pushing the sliding block up
and down on the handle.
INSTRUCTIONS FOR DRY VACUUMING

Before vacuuming dry dust, make sure that the HEPA filter and cloth filter bag is always fitted, regardless
of whether a paper dust bag is also used or not.

Empty dust from the tank as required.

The HEPA filter and cloth filter bag can be cleaned by beating or brushing it over a rubbish bin (these
must be replaced at regular intervals according to level of use)

In addition, the cloth filter bag can be washed with clean and warm water when it is covered with dust.
Make sure the cloth filter bag is completely dry before putting back in the machine.

When the tank is full of dust, this can cause the suction to decrease. You should turn the machine off and
disconnect the plug from the power socket before cleaning or maintenance.

Clean the dust away from the tank by unfastening the lid and lifting up the top cover. Then remove the
cloth filter bag and clean the dust inside the tank. Install the filter bag back and place the top cover on.
INSTRUCTIONS FOR WET VACUUMING

Always ensure that the HEPA filter, cloth filter bag and paper bags are removed before vacuuming water.

When the water in the barrel is full, the float begins to work. The suction power will disappear and the
machine will make a noise which indicates the motor is running at a high speed.

When the float is working and cutting off suction, you should turn off the machine and empty the dirty
water from the tank by unscrewing the drainage plug. The machine should start to work normally again.

If the machine becomes overturned you should turn it off, stand up the machine correctly and then turn
on the machine. When the float is working (cutting of suction when the water is full), the motor will be
damaged if you continue to use the machine. Under this circumstance, you should stop using the
machine and clean out the water.