21
EN
Emptying the dust container
1. Push the release button of the dust container and take it
out of the device by the handle.
2. Hold the dust container over an open dustbin. The dust
container should be as close as possible to the dustbin so
that the dust from the container falls only into the bin and
is not spread over the surrounding area.
3. Press the button to open the dust container. The bottom
of the dust container will open and the dirt will fall out.
4. Shut the dust container bottom again. The fastener must
audibly lock into place.
5. Put the dust container in the device: Take it by the handle and insert it bottom
fi
rst
into the device. Then push the handle towards the device housing until the dust
container audibly clicks into place. Hold the device by the dust container handle and
lift it up to check that the dust container is correctly locked into place.
Cleaning the cyclone insert and motor
fi
lters
The cyclone insert is situated inside the dust container. The motor
fi
lters are situated in
the
fi
lter holder on the cyclone insert.
1. Remove the dust container from the device and empty it (see section “Emptying the
dust container”).
2. Turn the lid of the dust container as far as it will go in an anticlockwise direction.
3. Remove the lid with the cyclone insert (
B
) from the dust
container.
4. Lift the tab on the lid, open the lid and remove the
fi
lter
holder (
C
) and remove the foam
fi
lter.
Please note: The second motor
fi
lter is attached to the
fi
lter holder and cannot be removed from the holder!
5. Tap out all the parts over a bin and brush away any loose
dirt.
6. If required, rinse out the
fi
lters thoroughly with clear, lukewarm water.
Attention: Do not use any cleaning products!
Next shake off any surplus water and leave the
fi
lters to air dry completely before
replacing them in the device.
7. You can clean the cyclone insert and dust container with a damp cloth.
8. After drying, place the foam
fi
lter back into the
fi
lter holder and replace the holder
onto the cyclone insert. Close the lid so that it audibly locks into place.
Attention: Never put damp parts back into the dust container!
9. When all parts are dry, replace the cyclone insert in the dust container.
C
B
09897_DE-EN-FR-NL_A5_V1.indb 21
09897_DE-EN-FR-NL_A5_V1.indb 21
19.01.2016 11:16:54
19.01.2016 11:16:54
