Cleanmaxx Premium Steam Cleaner, Руководство по эксплуатации

Страница: 19 / 48

19
Put on the floor cleaning cloth and the carpet glider
1. For putting on the floor cleaning cloth, stick the cleaning foot
into the floor cleaning cloth.
2. Tighten the covering with the cord by pushing the button and
pulling the cord. For cleaning your carpets, simply put the carpet
glider (13) over the floor cleaning cloth.
Use
❐
Before each use, check the floor cleaning cloth to be free from wear. It mustn’t be
used when it’s wear! Your flooring could be damaged!
❐
In order to avoid scratches on your surface, take care that the floor cleaning cloth
remains attached on the cleaning foot.
❐
Never point the steam at one place for more than 10 seconds.
❐
Never point the steam in the direction of other persons, animals or at utilities with
electrical components (e. g. ovens, fridges, switches and lamps, microwaves etc.).
❐
Never touch the underside of the steam cleaner while using it.
❐
Attention! The cleaning foot must never be held at an angle of greater than 45°
against the floor. Otherwise hot water could spatter out!
❐
The floor cleaning cloth still is very hot shortly after it’s use. Allow it to cool down
for 5 minutes, when you want to take it off.
❐
Always allow the device to cool down before storing it in a safe place.
• Before using the device, you might sweep the floor with a broom or vacuum-clean.
• Water residue in the filter and the tank can be traced back to the fact that this
device has been tested after the fabrication.
• During initial use, you’ll hear a pumping noise, because all of the relevant steam
cleaner parts has to be filled with water. You can accelerate this process by
pressing the steam trigger a number of times. When you use the device for
the second time the filter and feed lines will already be filled with water. If
the noise doesn’t disappear after 30 to 60 seconds, please refer to section
“Troubleshooting”.
• For winding up the cable, turn the cable retainer clockwise. Put the plug into a
mains socket, which complies with the device’s technical data (230 V AC, 50 Hz).
The red control lamp shines, when the supply voltage is reached.
06120_DE-GB-FR-NL_V1.indb 19 23.02.10 09:26