17
EN
8. Pull the device backwards along the same strip. The dirty water will be sucked up.
9. Start the next strip slightly overlapping the strip of carpet that has just been cleaned.
Work up to the other edge of the carpet with even movements forwards and back-
wards. If you
fi
nd more stubborn patches of dirt, go over a strip several times if nec-
essary.
10. If the dirty water container (
9
) is full up to the
MAX
marking, it must be emptied (see
the “Cleaning and Storage” chapter).
11. When the dirty water container is to be emptied, the fresh water container topped up
or the cleaning process
fi
nished, switch off the device by pressing the On / Off switch
again.
12. Place the device on the towel or cloth provided and move the handle forwards into an
upright position. It must click into place audibly.
13. Remove the mains plug from the plug socket.
After Use
• Empty both water containers after every use.
• Allow the freshly cleaned surfaces to dry completely.
• If possible, do not tread on the carpet while it is still damp. If it has to be trodden on,
put down white or colourfast towels and tread on them.
• If cleaning solution has got onto wooden
fl
oors or furniture, wipe it away.
•
Vacuum the dry carpet with a vacuum cleaner. To do this, use a brush attachment if
possible.
Cleaning and Storage
PLEASE NOTE!
■
The
fi
lters must
not
be cleaned in the washing machine.
■
Only ever dry the
fi
lters in the air, and never use a hair dryer to do so.
■
Do not use any chemical cleaning agents to clean the device. These may damage
the device.
1. Flip up the handle (
11
) on the dirty water container (
9
) and pull it up out of the basic
unit (
Picture I
).
2. The catch is located on the back of the dirty water container. Twist it 90° anticlockwise
to open it (
Picture J
).
3. Pour away the dirty water and rinse out the dirty water container thoroughly with
warm water.
4. The exhaust air
fi
lter (
10
) is located in the housing of the dirty water container. Press
the locking catch and pull out the
fi
lter holder (
Picture K
).
5. Remove the exhaust air
fi
lter from the holder and rinse it with warm water.
6. Take the motor protection
fi
lter out of the basic unit and rinse it with warm water
(
Picture L
).
7. Pour away the rest of the cleaning solution from the fresh water container and rinse
it thoroughly with warm water.
