Cleanmaxx 07023, Инструкция по эксплуатации

Страница: 25 / 56

25 EN
dry completely in the air . Place the plastic dust fi lter back
into the dust container when it is completely dry.
6. Insert the dust container in the device: Take hold of it by the handle and insert the
bottom of the bin in the device fi rst. Then push the handle against the device housing
until the dust bin audibly locks into place. Hold the device by the handle and lift it to
check whether the dust bin is properly seated.
Cleaning the exhaust fi lter
The device has two exhaust fi lters
• One exhaust fi lter is located in the compartment on the rear side of the vacuum
cleaner (see chapter “Product contents and device overview”, section “Rear view”).
1. Press the catch toward the compartment cover and re-
move the cover.
2. Remove the exhaust fi lter from the compartment.
3. Tap the exhaust fi lter out over a garbage bin and brush
off any loose dirt. If necessary, wipe out the compartment
with a damp cloth.
4. If necessary, rinse out the exhaust fi lter thoroughly with clean, lukewarm water.
ATTENTION: Do not in any case clean the fi lter in the washing machine or
dishwasher! Then shake off any remaining water and let the fi lter air dry completely
before reinstalling it.
5. Once all parts are dry, place the exhaust fi lter back into the fi lter compartment.
6. Fit the compartment cover again and press it down until it engages audibly.
• The other exhaust
fi lter is located beneath the dust container.
1. Push the release button on the dust bin and pull it out of
the device by the handle.
2. Remove the exhaust fi lter from the compartment.
3. Tap the exhaust fi lter out over a garbage bin and brush
off any loose dirt. If necessary, wipe out the compartment
with a damp cloth.
4. If necessary, rinse out the exhaust fi lter thoroughly with clean, lukewarm water.
ATTENTION: Do not in any case clean the fi lter in the washing machine or
dishwasher! Then shake off any remaining water and let the fi lter air dry completely
before reinstalling it.
Cleaning turbo nozzle
1. To make it easy to clean the turbo nozzle, you can open
the nozzle: To do this, twist the ring on the end piece of the
nozzle anticlockwise.
2. Carefully take off the top housing part. Now you can
remove hair, dust etc. from the brush.
3. After cleaning, put the nozzle back together again and turn
the ring in the clockwise direction until it clicks audibly into
place.
07023_DE-EN-FR-NL_A5_V1.indb 25 07023_DE-EN-FR-NL_A5_V1.indb 25 04.08.2017 10:36:13 04.08.2017 10:36:13