EN
20
Cleaning the motor
fi
lter
1. Remove the dust bin (see section “Emptying the dust bin”).
The motor
fi
lter (
1
) is located behind the dust bin in the
vacuum cleaner housing. It is protected by a foam
fi
lter.
2. Remove the foam
fi
lter.
3. Turn the frame with the
fi
lter counterclockwise and remo-
ve it. Reach into the two recesses on the frame in order to
rotate and remove the frame.
4. Shake out the
fi
lter over an open garbage can.
5. If needed, clean the
fi
lter with clear, lukewarm water and
allow it to dry completely. Do not insert the
fi
lter if it is still
moist.
6. Place the frame with the
fi
lter back in the vacuum cleaner
housing and turn it clockwise to secure it. Reach into the
two recesses on the frame as when removing it.
7. The motor
fi
lter is in place when the frame is
fl
ush with
the vacuum cleaner housing and the recesses on the
frame are perpendicular to the bracket (
D
) on the vacuum
cleaner housing and are vertically in line with one another
(see
fi
gure).
8. Make sure when inserting the dust bin that it engages
correctly in the vacuum cleaner housing. Therefore,
drepress and hold the release button when inserting
the dust bin and release the button when the button
pin is located unter the bracket on the vacuum cleaner
housing. Do not force the button pin into the bracket.
9. When inserted, the air intake pipe of the dust container must sit correctly on the
opening on the dust container housing (see picture) so that no air can escape at the
sides. After inserting the dust container, you should therefore switch on the device
and block the entrance to the suction tube on the handle with an object (e.g. a cush-
ion etc.) so that a vacuum can be produced and the air intake pipe can “
fi
rmly suck”
onto the opening on the vacuum cleaner housing.
Cleaning the exhaust
fi
lter
1. Open the exhaust
fl
ap on the back of the vacuum cleaner. The exhaust
fi
lter is
located behind the exhaust
fl
ap.
1
D
