- CARE, MAINTENANCE AND REPAIR -
Suction nozzle
To remove the suction bar, (1) open the wing nut (2). By pulling and twisting to the left, (3) the retaining
pin (4) on the right side can be hooked off. Remove the suction nozzle on the right (5) side.
To install it, push the suction bar from the right side (5) under the unit (between the roller and holder),
hook on the retaining pin, (4) and fasten the suction nozzle with the wing nut (2).
Replacing the suction lips
To replace the suction lips, unscrew the thumbscrews (1) and remove the front grip channel (2) as well as
the back grip channel (3). Now the suction lips (A/B) can be replaced. The suction lip with the indentations
must always be installed at the back (C). Then, put the grip channels (2/3) back into position and fasten
them with the thumbscrews (2).
Transport
Two ways to move or transport the Robo 40:
Method 1: Push the unit to the destination. When doing so, watch for obstructions in the floor quality and also
make sure that the suction nozzle is raised.
Note: When the unit is switched on, the Robo 40 can only be moved if the "Emergency off" button is pressed.
Method 2: Transport the Robo 40 with the service cart (A/B).
A
B
2
1
5
3
4
4
2
1
2
3
A
B
A
B
1
2
3
1
C
