H
OW
T
O
A
SSEMBLE
H
OW
T
O
U
SE
Y
OUR
D
UAL
S
UCTION
S
YSTEM
V
ACUUM
WARNING:
Plastic bags or film can be dangerous. To avoid danger of suffocation,
keep away from babies and children.
The dual Suction System is packaged for convenience and requires minimal assembly.
The only tool you will need is a Phillips head screwdriver.
1. Slide the handle Tube into the Connector, aligning the hole in the Handle Tube with
the molded hole at the top of the Connector.
2. Hold the hex nut in front of the Connector in the hex shaped cavity while inserting the
screw with your finger from the back. Tighten the screw while placing your finger over
the hex cavity to hold the hex nut in place. After a few turns, tighten further with a
Phillips head screwdriver. Do not overtighten.
3. Slide screw through plastic Cord Hook from the inside of Cloth Bag. Align screw with
hole in Handle Tube. Tighten screw.
4. Remove screw from Filter Cover. Remove Filter Cover. Insert the Connector Plug
into the back of the unit at the rear of the Powerfoot – Make sure the Connector Plug
is fully inserted. Replace Filter Cover. Replace Filter Cover Screw.
Your Vacuum cleaner is now ready to use.
Tip. Before cleaning under low furniture, always check area first for objects that might harm the Rotating
Cleaning Brush or get caught in the Dust Tube.
Power Supply
The Power Cord is stored at the back of the vacuum cleaner, and is looped around the Quick Release Cord
Hooks. The polarized Power Source Plug is designed to attach to the Power Cord during storage. Before
using, make sure the Connector Plug is securely attached to the Powerfoot and that the Power Source Plug is
plugged into a polarized outlet.
Power Switch
The Power Switch is located in the Handle of the cleaner. Push down (I) to turn ON. Push up (O ) to turn
OFF.
Power Cord Storage
When you are finished using your vacuum, return it to the upright position. Make sure the vacuum is turned
OFF. Always unplug the vacuum by grasping the Power Source Plug (NOT the Power Cord) and disconnect-
ing from the outlet. Properly store the Power Cord by winding the cord around the Quick Release Cord Hooks
on the back of the vacuum in a continuous loop, or by hanging the cord on the Cord Storage Hook located on
the front of the vacuum. Attach the Power Source Plug to the Power Cord.
Operation
This vacuum, with Dual Suction System is designed to effectively and safely clean all types of carpeting, wood,
linoleum, and vinyl floors. Its wide 14-inch Powerfoot makes cleaning quick and easy.
To place the vacuum in position for use, lightly press your foot on the Powerfoot and tip the Handle backwards.
