CleanCraft 7103662, Руководство по эксплуатации

Страница: 10 / 22

10 HDR-K Series | Version 1.03
Assembly
Fig. 5: Checking / filling in oil
Fill the fuel tank with unleaded petrol. Do not use 2-
speed mixture.
Water supply connection
Der direkte Anschluss an die Trinkwasserleitung ist nur
zulässig, wenn der Zulaufschlauch mit einem Rückflus-
sverhinderer gemäß den geltenden Vorschriften ausge-
stattet ist. Achten Sie darauf, dass der Schlauch minde-
stens Ø 13 mm beträgt, verstärkt ist und nicht länger als
25 m ist.
Suction of water from open containers
Step 1: Screw the inlet hose with filter to the water INLET
and insert it down to the bottom of the container.
Step 2: Vent the air from the appliance:
a) Unscrew the lance.
b) Start the appliance and keep the gun open
until there are no air bubbles in the water flowing
out.
Step 3: Switch the appliance off and screw the lance
back on. The maximum suction height is 0.5
m. The suction hose should be filled before
use.
:
Fig. 6: Water supply
Hand spray gun, lance and nozzle
Step 1: Connect the nozzle to the hand spray gun and
tighten.
Step 2: Connect the high pressure hose to the hand
spray gun and the water tank.
Step 3: Screw the selected nozzle onto the nozzle
connector of the hand spray gun.
Fig. 7: Assembling the hand spray gun
ATTENTION!
Only clean or filtered water should be supplied to the
appliance. The flow rate of the water inlet tap should
be equal to the pump flow rate.
Place the appliance as close to the water supply
system as possible.