cleanAIR 720600L, Руководство пользователя

Страница: 9 / 104

9
Outlet valve
(see Figures Annex 6.1 - 6.4)
1 . Slightly press on the valve body with your fingers from the side and remove the cover.
NOTICE
Outlet valves are located on both sides of the mask.
2. Press a new inlet valve membrane into the inner mask opening.
3. Hold the membrane stem and turn it to verify its stability under load.
4. Close the valve body.

Inner mask
(see Figures Annex 7.1 - 7.2)
1. Pull the inner mask to remove it.
2.
Insert a new inner mask into the face-piece section according to the drawing, seal the first
one A(a), B(b) and finally C(c), in this order.
Front cover
1.
Use a hexagonal wrench to remove the two screws on the front side and then remove the
front cover.
2. Use the screws to fasten a new front cover.
Headband
(see Figures Annex 8.1 - 8.4)
1. Pull the two pawls of the headband from the upper section of the buckle.
2. To release the buckle turn it on its pin by 90° clockwise and counter-clockwise.
3. Slide off the buckle to remove the head piece.
4. Replace the pin.
5. Install a new headband.
Instructions for use CF02 Full-Face Mask ENG