Clean Athena Perafoam, Руководство пользователя

Страница: 8 / 16

Page 8 Athena
®
Reset Foamer
USA
USA
Chemical
suction line
Chemical
suction line
2
Injector
inlet barbs
Dual chemical
injector
1
3
3
2
3. Operation
1. Fill the tank with water.
2. Follow all instructions from chemical
manufacturer. Fill the chemical container with
chemical concentrate.
2a. Fill Perafoam chemical container with
Athena
®
Perafoam.
2b. Fill Reset chemical container with
Athena
®
Reset.
3. Connect each suction line to quick-connect
fi ttings on 5 gallon chemical jugs.
4. Verify that the suction line valve at the base of
the suction line is open, to allow fl uid into the
suction line.
5. With the discharge ball valve in the closed
position, plug an air line into the air fi tting.
6. Slowly open the discharge ball valve to begin
foaming. The discharge ball valve should be
completely open while foaming.
7. While the unit is running and discharging
product, adjust the fl ow control valve as
needed to regulate the wetness or dryness of
the foam following the steps below:
a. Close needle valve completely in
clockwise direction.
b. Open needle valve in counter-clockwise
direction 3 complete turns.
c. Continue to open needle valve in ¼
turn increments, allowing 30 seconds
between adjustments, until desired
consistency of foam is achieved.
8. Close the discharge ball valve to stop foaming.