18
OPERATIONS MANUAL
19
RHINO-MAT
COIN LEARN PROCEDURE
1. Slide the front cover up and identify the three controls to be used in this
procedure:
a) The “test” push button near center bottom. (used to input the number
of credit pulses)
b) 16 position rotary switch to the right of the push-button. (#0 is normal
RUN position, #1-#6 are for learning each of 6 possible coin types that
can be accepted)
c) LED indicator half way up on the right side. (Green in RUN mode, red
in LEARN mode)
2. Turn the rotary switch to one of the LEARN positions #1-#6 (for example,
pick #3 for learning the 3rd coin type) and observe the LED turns red to
indicate it is now ready to learn.
3. Push the test button once for each credit pulse you wish to have issued
for this coin. For example, a $1 coin would require 4 credit pulses if you
are also accepting $0.25 coins for one credit pulse. Note: With V3.0-t or
and V4.0 firmware, only a single credit and sense pulse will be produced
no matter how many times you push the button. Contact the factory if
you require multiple pulses for your application.
4. Slide the cover back on the unit to make sure outside light is does not
interfere with the sensors.
5. Show the unit 6 samples of the coin by depositing them into the acceptor
as usual. It is best to use 6 different coins since there are typically slight
variations from coin-to-coin.
6. After the 6th sample coin is deposited, the LED will flash red-green a
few times to indicate the LEARN procedure is complete and the coin
parameters are stored in memory.
CONFIGURING THE HAWK XEPTOR
COIN ACCEPTOR
COIN UN-LEARN PROCEDURE
1. Slide the front cover up and turn the rotary switch to the coin # position
you wish to UN-LEARN.
2. Push the test button once to initiate the LEARN sequence.
3. Turn the rotary switch back to position #0 without depositing any coins
to signal the unit that you wish it to erase the parameters for this coin.
The LED will flash red-green to indicate completion.
4. Slide the front cover back down.
Hawk Exeptor coin acceptor is supported directly by IDX Inc, Clean World
Distribution Inc can only provide basic support or replacement of the
component in the event of a catastrophic failure. For trouble shooting and
all other support please contact IDX Inc directly via their toll free number:
800-643-1109 or on the web at www.idxinc.com
7. Slide the front cover open again and turn the rotary switch back to
position #0 and observe the LED turning green. Check that you have
not accidentally turned it too far to position #15 which is a field test
function position, in which it will not accept coins.
8. Slide the front cover back down and you should now be able to accept
the new coin.
