Clean Water Systems Greensand 7500, Инструкция по установке и запуску

Страница: 9 / 13

7500 Pro ‐ Ox Filter Installation & Startup Guide
Page 9 www.cleanwaterstore.com
Rev 060116
B. Button lock indicator
• When the green Key Icon is lit, the buttons are locked. Press and hold both the Up and Down
arrows to unlock. Buttons will lock 60 seconds after the last time a button is pressed.
C. Program mode indicator (shown on drawing as Enquiry/ Setting) is the green Wrench Icon.
To activate this Icon from Service Mode, press and release the Menu/Confirm button (button
on far left, with a square and an arrow pointing left) and the green Wrench Icon will be lit.
• With the green Wrench icon lit, you can press either the scroll Up or scroll Down buttons to
navigate to each menu item. You will do this in order to:

Set/confirm that the valve is programmed for Non ‐ external input mode.

Set Current Clock Time

Set the time when you want the filter to backwash

Set the number of complete backwash cycles it will do at that time

Set how many days between backwashes

Set the number of minutes for the Backwash Cycle

Set the number of minutes for the Rapid Rinse Cycle.
• When the green Wrench Icon is flashing, whatever parameter that is selected (set clock time,
set cycle step, etc.) can now be adjusted by using the Scroll buttons.
For example, When you press it the first time, the Dynamic service Stripe goes away, the Green
Wrench Icon is lit, and the other icon that is lit is the Blue Clock Icon ‐ that means that whatever
digits are on the red display, they are stating the clock time (in 24 hour mode). When you press
the menu/ Confirm button again, the Hours will flash, and now you can change the hour by
pressing the scroll arrows. When you are at the correct hour, press the Menu/Confirm button,
and the Minutes will flash. After adjusting the minutes with the Scroll arrow, pressing the
Menu/Confirm one more time displays your currently set clock time, and the digits are not
flashing.
Programming the 7500 Valve:
There are seven menu items that we will set and confirm, to program your
Greensand
filter.
Plug the valve in, and wait for the Service Screen to come on, the Dynamic Display Strip is
blinking.
If the green Key Icon is lit, press and hold both Scroll Buttons. The valve will beep and the key
Icon will disappear.