CLEAN REMOTE FOR MULTI-BED TV INSTRUCTIONS
FOR HEALTHCARE TVs WITH THIS FUNCTION ONLY
CR3BCB-H
MULTI-BED TV CODES
RESET: To reset remote back to original manufacturer settings, or reset the
remote to operate a standard TV:
Press hold both the Setup and the CC button down at
the same time until the red LED light blinks quickly 3 times, then release both buttons. Then
follow the Easy Setup instructions below.
EASY STANDARD TV SETUP (No Multi-Bed)
1.
Turn on the TV and then s
tand back about 5 feet from TV and
P
oint the remote at the CENTER of
the front panel of the TV.
It will not be necessary to point the remote at that exact area once the remote is
set-up.
2.
Press and
firmly
Hold
down the
Setup
button, do not release. The LED will blink once and then
after 7 seconds it will start code search. The LED will continue to blink every 2 seconds. Once your
TV shuts off immediately remove your finger from the Setup button; the code automatically locks
in.
3.
Testing the remote:
For TV Only:
Test Power, Volume and Channel Functions,
if all work correctly setup is
complete.
If not, you may not have an exact code match. Start again at step #1. The code search
will continue where it left off.
Important Note: If you think you missed the code or you intend to use the remote on a different
brand TV:
See RESET instructions above.
