3 of 4
7. Repeat Step 6 for the Angle Brace and Under Support at the other end of the Table.
After both Braces have been attached to the Center Brace Mount, add a Flat Washer and Flanged Nut to the end of the Carriage
Bolt. Leave the hardware finger tight so the Tabletop can be adjusted and leveled later.
Flat Washer
Flanged Nut
Carriage Bolt
Angle Brace
Angle
Brace
Angle Braces
Apply hardware
to outer Bolt only
Seat Stiffener
Support
Note:
Only add hardware to one
of the Carriage Bolts.
Note orientation of
Seat Stiffener Support
8. Place one of the Seat Stiffener Supports over the two carriage bolts in the center of one of the Seat Planks. Add a Flat Washer
and Flanged Nut to one of the Carriage Bolts and tighten with the Wrench and Socket. Repeat this step for the other Seat Plank.
Center Brace
Mount
Center Brace
Mount
9. Raise one of the Seat Planks up to the Seat Mounting Bracket on one of the Under Supports. Orient the Seat Plank so that the
Nut and Washer on the Seat Stiffener Support is toward the outside edge. Add a Washer and Nut to the Carriage Bolt through the
Seat Bracket on the outside edge of the Seat Plank. Leave the hardware finger tight until the Seat Stiffener is attached.
Place the Seat Stiffener over the three Carriage Bolts on the inside edge of the Seat Plank and add a Washer and Nut to each of
the Carriage Bolts. Tighten all of the Seat hardware.
Seat Stiffener
Carriage Bolts
taped in place
