13
PTC heating element
Transducer
Cleaning the transducer/PTC heating element and water basin
Unplug the device.
During cleaning and descaling, the device must not be used.
Remove any splashes of
Clean Air Optima® Cleaner & Descaler
from work surfaces or the out-
side of the device with a soft, damp cloth.
1. Pour two capfuls of
Clean Air Optima® Cleaner & Descaler
into the water basin (one onto the
surface of the
transducer
and
one
onto the
PTC heating element
) and leave for between two
and five minutes.
2. Carefully remove the mineral (lime) layer from the surface of the
transducer
and
PTC heater
with a small brush, cotton swab or toothbrush.
Caution: never use sharp or hard objects to clean the transducer/PTC heating element.
3. Then add water up to the rim of the
water basin
and leave for a minimum of 30 and a maxi-
mum of 60 minutes.
4. Rinse the
transducer/PTC heating element
and
water basin
thoroughly with water.
5. If there are still traces of limescale visible, we recommend that you repeat the cleaning and
descaling process.
6. Clean the inside of the
water tank
with a mild detergent and rinse with clean water.
After cleaning and descaling, your device is hygienically clean, free of limescale, free of bacteria,
free of viruses and immediately ready for use again.
Please note:
For cleaning and descaling, the device must be turned off/unplugged, so that no acid is re-
leased into the air via aerosols through ultrasonic misting.
Содержание CA-606B
Страница 2: ...2 CA 606B Main unit CA 606B Display ...