I-FORM
Subject:
W1600 WAMM
Reference: U1283_RQ_2210
Status:
Pending
Version:
9
Approver: XX
Filename: U1283_RQ_2210_IFORM_W1600.doc
page 25 of 29
2.5.2.2
Default settings
Setting
Description
Values*
Audio configuration
Sample rate
Sample rate of audio connection
(8 kHz) / 16 kHz
Microphone volume
Alter this value if the sound from the
room is to loud or to soft.
-12dB to 12dB (0dB)
Speaker volume
Alter this value if the sound in the room
is to loud or to soft.
-12dB to 12dB (0dB)
Audio LED indication
Should the LED be turned on or off
during an active audio connection
(On) of Off
Pre-trigger recording
time
How many seconds of sound should be
recorded before the sound trigger
occurred
1s to 14s (8s)
Total recording time
The total time of a recording
2s to 16s (16s)
Interval between
audio notifications
The minimum time between reporting an
audio notification to the system
1s to 30s (30s)
Button configuration
Min. LED brightness
idle
The minimum brightness of the button
LED’s in idle mode**
0% to 50% (1%)
Max. LED brightness
idle
The maximum brightness of the button
LED’s in idle mode**
0% to 50% (35%)
Pear push / handset
Min. LED brightness
idle
The minimum brightness of the pear
push LED’s in idle mode**
0% to 50% (1%)
Max. LED brightness
idle
The maximum brightness of the pear
push LED’s in idle mode**
0% to 50% (5%)
* All values mentioned between ( ) are default values.
** LED brightness is adjusted between the configured min. and max. values by the module’s light
sensor.
2.5.2.3
Required software applications
•
The W1600 is fully supported from suite v.3.9 or higher.
•
Please refer to the Configurator manual for instructions on how to update this module’s
firmware and change the settings described above.
2.6
Specific remarks
2.6.1
Connector
There is only one allowed connector orientation! This is shown in 1.4.3.2.
